Cryogenic drilling of carbon fibre reinforced thermoplastic and thermoset polymers
- 18 June 2020
- journal article
- research article
- Published by Elsevier BV in Composite Structures
- Vol. 251, 112625
- https://doi.org/10.1016/j.compstruct.2020.112625
Abstract
No abstract availableKeywords
This publication has 32 references indexed in Scilit:
- Temperature measurement of cutting tool and machined surface layer in milling of CFRPInternational Journal of Machine Tools and Manufacture, 2013
- Influence of Cutting Heat on Quality of Drilling of Carbon/Epoxy CompositesMaterials and Manufacturing Processes, 2012
- Reduction of Burr Formation in Drilling Using Cryogenic Process CoolingProcedia CIRP, 2012
- Drilling of polymer matrix composites: A reviewJournal of Composite Materials, 2012
- Drill geometry and operating effects when cutting small diameter holes in CFRPInternational Journal of Machine Tools and Manufacture, 2009
- The dependency of material properties and process conditions on the cutting temperatures when drilling polymersProduction Engineering, 2007
- Effects of special drill bits on drilling-induced delamination of composite materialsInternational Journal of Machine Tools and Manufacture, 2005
- Chisel Edge and Pilot Hole Effects in Drilling Composite LaminatesJournal of Manufacturing Science and Engineering, 2002
- Some experimental investigations in the drilling of carbon fiber-reinforced plastic (CFRP) composite laminatesInternational Journal of Machine Tools and Manufacture, 1997
- Quality Definition and Assessment in Drilling of Fibre Reinforced ThermosetsCIRP Annals, 1989