Wireless Structural Health Monitoring Using MEMS
- 1 September 2005
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 293-294, 625-634
- https://doi.org/10.4028/www.scientific.net/kem.293-294.625
Abstract
So far, the inspection of building structures and especially of bridges is mainly done visually. Therefore, the condition of the structure is examined from the surface and the interpretation and assessment is based on the experience of the expert. However, the main purpose of monitoring civil structures is not to substitute visual inspection. Continuous structural health monitoring should provide data from the inside of a structure to better understand its structural performance and to predict its durability and remaining life time. Monitoring should render objective data and observable alterations in the structure continuously, which cannot be done by visual inspection. More detailed information is needed with respect to different exposure due to dynamic and static loads and also temperature and moisture. Today mainly wired monitoring systems are used to monitor structures, which are relatively expensive and time consuming to install. In this paper the basic principle of a wireless monitoring system equipped with MEMS sensors is presented, which can be easily installed at different structures. Microelectromechanical systems (MEMS) are small integrated devices or systems that combine electrical and mechanical components. A wireless monitoring sensor network equipped with such MEMS could be produced with a very low budget and becomes very efficient. This permits a wide area of applications not only in civil engineering. With respect to different applications relevant properties of a wireless monitoring system are described. In detail network configuration, power consumption, data acquisition and data aggregation, signal analysis and data reduction as well as reliability and robustness are discussed.Keywords
This publication has 14 references indexed in Scilit:
- Efficient clustering algorithms for self-organizing wireless sensor networksAd Hoc Networks, 2006
- Tinycubus: a flexible and adaptive framework for sensor networksPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Experimental study of the effects of transmission power control and blacklisting in wireless sensor networksPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Generic role assignment for wireless sensor networksPublished by Association for Computing Machinery (ACM) ,2004
- Smart wireless autonomous microsystems (SWAMs) for sensor actuator networksPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2004
- Networking support for query processing in sensor networksCommunications of the ACM, 2004
- Power Sources for Wireless Sensor NetworksLecture Notes in Computer Science, 2004
- MEMS for distributed wireless sensor networksPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Taming the underlying challenges of reliable multihop routing in sensor networksPublished by Association for Computing Machinery (ACM) ,2003
- A low-power, high-performance, 1024-point FFT processorIEEE Journal of Solid-State Circuits, 1999