Selective laser sintering/melting (SLS/SLM) of pure Al, Al–Mg, and Al–Si powders: Effect of processing conditions and powder properties
- 1 August 2013
- journal article
- Published by Elsevier BV in Journal of the American Academy of Dermatology
- Vol. 213 (8), 1387-1405
- https://doi.org/10.1016/j.jmatprotec.2013.03.009
Abstract
No abstract availableKeywords
This publication has 19 references indexed in Scilit:
- Experimental investigation on selective laser melting behaviour and processing windows of in situ reacted Al/Fe2O3 powder mixturePowder Technology, 2012
- Selective laser melting of aluminium componentsJournal of the American Academy of Dermatology, 2010
- Densification mechanism and microstructural evolution in selective laser sintering of Al–12Si powdersJournal of the American Academy of Dermatology, 2010
- Balling phenomena in direct laser sintering of stainless steel powder: Metallurgical mechanisms and control methodsMaterials & Design (1980-2015), 2009
- Shear strength and sliding at a metal–ceramic (aluminum–spinel) interface at ambient and elevated temperaturesActa Materialia, 2007
- Balling phenomena during direct laser sintering of multi-component Cu-based metal powderJournal of Alloys and Compounds, 2006
- Binding mechanisms in selective laser sintering and selective laser meltingRapid Prototyping Journal, 2005
- Effects of laser sintering processing parameters on the microstructure and densification of iron powderMaterials Science and Engineering: A, 2003
- Instability of scan tracks of selective laser sintering of high speed steel powderScripta Materialia, 1999
- Selective laser sintering of gas and water atomized high speed steel powdersScripta Materialia, 1999