The Use of TiAlN Coated Carbide Tool when Finish Drilling of Stainless Steel X4Cr17Ni8TiN
- 1 November 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 39, 369-374
- https://doi.org/10.4028/www.scientific.net/amm.39.369
Abstract
In this paper presents the conclusions of machinability tests on a new stainless steel X4Cr17Ni8TiN, which applicated in food processing industry, and describes important concurrent parameters for the cutting zone during the process of finish drilling. This paper presents the results of experiments that concerned the verification of temperature fields in tool and the machined surface by drilling of stainless steels X4Cr17Ni8TiN. The content of this paper also focuses on the analysis of selected domains through basic indicators of steel machinability: cutting edge tool life, surface roughness, and wear mechanisms. The machinability of stainless steels is examined based on the cutting tests. The effect of cutting speed are analysed by tool wear mechanisms, and temperature tool. Based on the cutting tests, cutting speeds of 40 to 80 m/min, feed rate of 0.04 to 0.1 mm per rev.and solid a new design of screw drill from sintered carbide with hydraulic holder. Diameter of screw drill is 5.5 mm. Tool wear criterion of VBK value 0.12 mm. Wear mechanisms analysed by Semi Electron Microscopy (SEM).Keywords
This publication has 9 references indexed in Scilit:
- Accompanying phenomena in the cutting zone machinability during turning of stainless steelsInternational Journal of Machining and Machinability of Materials, 2009
- Verification of cutting zone machinability during drilling of austenitic stainless steelsPublished by SPIE-Intl Soc Optical Eng ,2008
- Monitoring and Diagnosis of Drill Wear and the Thermodynamic Phenomenas of Material Removal by Drilling of Stainless SteelsPublished by Springer Science and Business Media LLC ,2007
- Comparative assessment of surface roughness produced by hard machining with mixed ceramic tools including 2D and 3D analysisJournal of the American Academy of Dermatology, 2005
- Using Wear Curves to Predict the Cost of Changes in Cutting ConditionsJournal of Manufacturing Science and Engineering, 1998
- Experimental investigation of overall machining performance with overall progressive tool wear at different tool facesWear, 1994
- Chip Flow and Notch Wear Mechanisms during the Machining of High Austenitic Stainless SteelsCIRP Annals, 1994
- A Remote Temperature Sensing Technique for Estimating the Cutting Interface Temperature DistributionJournal of Engineering for Industry, 1986
- Tool Wear Investigations on Some Cutting Tool MaterialsJournal of Lubrication Technology, 1980