The effect of process and material parameters on the coefficient of friction in the flat-die test
- 1 April 2010
- journal article
- Published by Elsevier BV in Journal of the American Academy of Dermatology
- Vol. 210 (6-7), 868-876
- https://doi.org/10.1016/j.jmatprotec.2010.01.019
Abstract
No abstract availableKeywords
This publication has 8 references indexed in Scilit:
- The effect of lubricant additives on the coefficient of friction in the flat-die testMaterials Science and Engineering: A, 2006
- The Influence of Lubricant Film Thickness on Friction Coefficients During Slow Speed Deep Drawing OperationsJournal of Tribology, 2002
- Transfer layer and friction in cold metal strip rolling processesWear, 2000
- FEM Analysis of Hydrostatic Pressure Generated Within Lubricant Entrapped Into Pocket on Workpiece Surface in Upsetting ProcessJournal of Tribology, 1999
- Tool Surface Topographies for Controlling Friction and Wear in Metal-Forming ProcessesJournal of Tribology, 1998
- A Critical Review of the Applicability of Tribotesters to Sheet Metal workingPublished by SAE International ,1997
- Measurements of Friction in Cold Metal RollingJournal of Tribology, 1996
- Effects of Lubricant Viscosity at Pressure and Sliding Velocity on Lubricating Conditions in the Compression-Friction Test on Sheet MetalsJournal of Lubrication Technology, 1982