Improving the predictions of injection molding simulation software
- 25 July 2011
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 51 (12), 2542-2551
- https://doi.org/10.1002/pen.22035
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Development of Injection Molding SimulationPublished by Carl Hanser Verlag ,2009
- Pressure-dependent viscosity and free volume of atactic and syndiotactic polystyreneRheologica Acta, 2009
- Evaluation and comparison of routes to obtain pressure coefficients from high-pressure capillary rheometry dataRheologica Acta, 2006
- Effect of machine compliance on mold deflection during injection and packing of thermoplastic partsPolymer Engineering & Science, 2006
- Modeling of morphology evolution in the injection molding process of thermoplastic polymersProgress in Polymer Science, 2005
- Pressure Effect on Viscosity for Atactic and Syndiotactic PolystyrenePolymer Bulletin, 2005
- Relevance of mold‐induced thermal boundary conditions and cavity deformation in the simulation of injection moldingPolymer Engineering & Science, 2001
- Nature of contact between polymer and mold in injection molding. Part II: Influence of mold deflection on pressure history and shrinkagePolymer Engineering & Science, 2000
- POLYMER PROPERTIESPublished by Elsevier ,1997
- Modifying the tait equation with cooling‐rate effects to predict the pressure–volume–temperature behaviors of amorphous polymers: Modeling and experimentsPolymer Engineering & Science, 1996