Biomechanical characterization of osseointegration: An experimental in vivo investigation in the beagle dog
- 1 January 1998
- journal article
- research article
- Published by Wiley in Journal of Orthopaedic Research
- Vol. 16 (1), 61-69
- https://doi.org/10.1002/jor.1100160111
Abstract
This study reports the results of torsion tests, pull‐out tests, and lateral Ioading tests on osseointegrated commercially pure titanium fixtures. The tests were performed in vivo on six beagie dogs. Three fixtures, each with a diameter of 3.7mm, were installed bilaterally in the tibia of each animal. The mean maximal pull‐out load was 1.55 kN (n = 4) the mean maximal lateral transverse load was 0.21 kN (n = 2), the mean maximal lateral axial load was (0.18 kN (n = 2)) the mean breakpoint torque was 0.31 Nm (n = 3), and the mean maximal torque was 0.43 Nm (n = 3). The torsion test revealed an almost immediate plastic deformation of the interface between the implant and bone: this indicates that although the contact between the bone and the implant is close, there is no strong bond, at least not in shear. The major transfer of load from the implant to the surrounding bone tissue must therefore depend on the design of the implant. A histological evaluation with measurements of the amount of bone in contact with the fixtures was performed. By the use of the histological and mechanical data, it is possible to estimate shear stresses in bone tissue (pull‐out test) and in the interface (torque test), The mean maximal shear stress in bone tissue in the pull‐out tests was 100 MPa (n = 4); the mean shear stress in the interface was 4.3 MPa (n = 3) in the torsion tests at the breakpoint torque and was 6.0 MPa (n = 3) at the maximal torque. It was also possible to estimate the shear modulus of elasticity in the pull‐out and torque tests. The mean shear modulus in pull‐out was 119 MPa (n = 4), and the mean apparent shear modulus in torsion was 9 kPa (n = 3) for an assumed interface thickness of 100 nm and was 86 kPa (n = 3) for an assumed interface thickness of 1.000 nm.Keywords
This publication has 8 references indexed in Scilit:
- Bone bonding behavior of titanium and its alloys when coated with titanium oxide (TiO2) and titanium silicate (Ti5Si3)Journal of Biomedical Materials Research, 1996
- Osseointegrated thumb prostheses: A concept for fixation of digit prosthetic devicesThe Journal of Hand Surgery, 1996
- Osseointegration from the Perspective of the Plastic SurgeonPlastic and Reconstructive Surgery, 1994
- Osseointegration of titanium implants in the tibia: Electron microscopy of biopsies from 4 patientsActa Orthopaedica, 1994
- Metacarpophalangeal Joint Arthroplasty Based on the Osseointegration ConceptJournal of Hand Surgery (European Volume), 1993
- Finite Element Models of Implants in Bone: Interfacial AssumptionsPublished by Springer Nature ,1985
- A method for the study of undecalcified bones and teeth with attached soft tissues*Journal of Oral Pathology & Medicine, 1982
- Intra-Osseous Anchorage of Dental Prostheses:I. Experimental StudiesScandinavian Journal of Plastic and Reconstructive Surgery, 1969