Co‐injection molding of reinforced polymers
- 1 October 1983
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 4 (4), 256-264
- https://doi.org/10.1002/pc.750040411
Abstract
No abstract availableKeywords
This publication has 21 references indexed in Scilit:
- Rheology of reinforced thermoplastics and its application to injection‐molding: IV. Transient injection capillary flow and injection‐moldingPolymer Engineering & Science, 1982
- Studies on structural foam processing I. The rheology of foam extrusionPolymer Engineering & Science, 1978
- Stratified two‐phase flog of molten polymers in circular diesPolymer Engineering & Science, 1977
- Theory of Interface Distortion in Stratified Two-Phase FlowTransactions of the Society of Rheology, 1975
- An experimental study of sandwich injection molding of two polymer melts using simultaneous injectionPolymer Engineering & Science, 1975
- Fibre orientation distribution in short fibre reinforced plasticsJournal of Materials Science, 1975
- Flow visualization for injection molding of polyethylene and polystyrene meltsPolymer Engineering & Science, 1974
- A study of bicomponent coextrusion of molten polymersJournal of Applied Polymer Science, 1973
- Co‐current stratified laminar flow of two immiscible liquids in a rectangular conduitThe Canadian Journal of Chemical Engineering, 1965
- The horizontal pipeline flow of equal density oil‐water mixturesThe Canadian Journal of Chemical Engineering, 1961