Physics in metal cutting
- 1 March 1973
- journal article
- Published by IOP Publishing in Reports on Progress in Physics
- Vol. 36 (3), 223-288
- https://doi.org/10.1088/0034-4885/36/3/001
Abstract
No abstract availableKeywords
This publication has 47 references indexed in Scilit:
- Metal cutting: Mechanics, surface physics and metallurgyInternational Journal of Mechanical Sciences, 1972
- Fine structure of machined surfacesInternational Journal of Machine Tool Design and Research, 1970
- Photoelastic analysis of stresses and forces in steady cuttingJournal of Strain Analysis, 1968
- Some new slip-line solutions for two-dimensional steady-state machiningInternational Journal of Mechanical Sciences, 1965
- Thermal Crack in the Carbide Face-Milling Cutter : 2nd Report, Its Significance as a Cause of Tool FailuresBulletin of JSME, 1963
- Thermal Crack in the Carbide Face-Milling Cutter : 1 st Report, Results Obtained from the Fundamental Cutting ExperimentsBulletin of JSME, 1962
- An investigation of the transition from a continuous to a discontinuous chip in orthogonal machiningInternational Journal of Mechanical Sciences, 1961
- A theoretical investigation of the temperature distribution in the metal cutting processBritish Journal of Applied Physics, 1954
- The mechanics of machining: A new approachJournal of the Mechanics and Physics of Solids, 1954
- On the use of hodographs in problems of plane plastic strainJournal of the Mechanics and Physics of Solids, 1954