Modeling Mercury Removal by Sorbent Injection
- 1 June 1999
- journal article
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 49 (6), 694-704
- https://doi.org/10.1080/10473289.1999.10463836
Abstract
Sorbents for removing mercury from flue gases of coal-fired power plants are presently being evaluated due to potential regulation of mercury emissions under Title III of the 1990 Clean Air Act Amendments. Laboratory tests have been conducted to evaluate the adsorption characteristics of potential sorbents and the effects of flue gas constituents on these characteristics. This paper presents a theoretical model that combines the adsorption characteristics measured in the lab with mass transfer considerations to predict mercury removal by the duct injection process in actual flue gas streams. The model was used to determine the effect of various sorbent properties on mercury removal when injecting a powdered sorbent upstream of either an electrostatic precipitator (ESP) or fabric filter. Mercury removal is expected to differ between these configurations since the mass transfer conditions are different in an ESP and fabric filter. The model was used to determine when mercury removal is limited by mass transfer and when it is limited by sorbent capacity. This information defines conditions when removal can be improved by reducing particle size or increasing sorbent capacity. In both cases, removal can be increased by injecting more sorbent.Keywords
This publication has 2 references indexed in Scilit:
- Factors Affecting Mercury Control in Utility Flue Gas Using Activated CarbonJournal of the Air & Waste Management Association, 1998
- Modeling Powdered Activated Carbon Injection for the Uptake of Elemental Mercury VaporsJournal of the Air & Waste Management Association, 1998