Fabrication of Metal and Alloy Components by Additive Manufacturing: Examples of 3D Materials Science
Open Access
- 1 April 2012
- journal article
- review article
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 1 (1), 42-54
- https://doi.org/10.1016/s2238-7854(12)70009-1
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Comparison of Microstructures and Properties for a Ni-Base Superalloy (Alloy 625) Fabricated by Electron Beam MeltingJournal of Materials Science Research, 2012
- Microstructures and mechanical behavior of Inconel 718 fabricated by selective laser meltingActa Materialia, 2012
- Microstructural Architecture, Microstructures, and Mechanical Properties for a Nickel-Base Superalloy Fabricated by Electron Beam MeltingMetallurgical and Materials Transactions A, 2011
- Open-cellular copper structures fabricated by additive manufacturing using electron beam meltingMaterials Science and Engineering: A, 2011
- A study of the microstructural evolution during selective laser melting of Ti–6Al–4VActa Materialia, 2010
- Microstructure and mechanical behavior of Ti–6Al–4V produced by rapid-layer manufacturing, for biomedical applicationsJournal of the Mechanical Behavior of Biomedical Materials, 2008
- Investigations of MX and γ′/γ″ precipitates in the nickel-based superalloy 718 produced by electron beam meltingMaterials Science and Engineering: A, 2007
- Some aspects of the precipitation of metastable intermetallic phases in INCONEL 718Metallurgical Transactions A, 1992
- The strength, fracture toughness, and low cycle fatigue behavior of 17-4 PH stainless steelMetallurgical Transactions, 1974
- Morphology of y’ and y” precipitates and thermal stability of inconel 718 type alloysMetallurgical Transactions, 1973