The frontiers of magnetic bubble technology
- 1 January 1975
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Proceedings of the IEEE
- Vol. 63 (8), 1196-1206
- https://doi.org/10.1109/proc.1975.9913
Abstract
Two areas of major emphasis in the development of magnetic bubble memories are discussed: the effort to increase the bit-packing density and the effort to increase the operating speed of these memories. It is pointed out that increasing the density by scaling down an existing chip design involves consideration of not only lithographic and fabrication problems, but also magnetic materials problems. High density chips may be obtained with at least three different chip configurations: 1) the familiar Permalloy-bar file (PBF) employing T-bar figures, but fabricated with electron-beam lithography and single-level masking; 2) the contiguous-disk file (CDF) which utilizes relatively coarse Permalloy patterns and hence eases lithography requirements; and 3) the bubble-lattice file (BLF) which employs closely packed bubbles with a novel wall-structure data-coding scheme. The relative advantages of these three schemes are compared: the PBF has been developed the farthest and is the only configuration employing single-level masking; the highest density is offered by the CDF if lithography is not the limiting factor, and by the BLF if the achievement of small-diameter bubbles is the limiting factor. Two factors which govern the operating speed of a bubble memory are discussed: the velocity of propagation of a bubble and the organization of the memory so as to achieve the shortest possible access and latency times. Significant progress is being made in the development of bubble materials which support high bubble velocities; this progress is based on understanding of complex changes in wall structure which occur during bubble motion. The advantages of the major/minor loop and coincident-selection organizational schemes in reducing access times and in sharing interconnections and electronics are reviewed. The capabilities of the magnetic bubble memory technology are briefly compared with those of the semiconductor and magnetic disk technologies.Keywords
This publication has 35 references indexed in Scilit:
- Bubble ladder for information processingIEEE Transactions on Magnetics, 1975
- Amorphous film magnetic bubble domain devicesIEEE Transactions on Magnetics, 1975
- Ballistic overshoot in the gradient propagation of bubbles in garnet filmsApplied Physics Letters, 1975
- Gallium concentration effects on magnetic bubble films of EuTm2(Fe,Ga)5O112 garnet grown by liquid phase epitaxyMaterials Research Bulletin, 1975
- Dynamic conversion of magnetic bubble domain walls at megahertz frequencies in epitaxial garnet filmsApplied Physics Letters, 1975
- Magnetic bubble mass memoryIEEE Transactions on Magnetics, 1975
- Bubble to T-I bar coupling in amorphous film small bubble devicesIEEE Transactions on Magnetics, 1974
- Submicron bubble domain device designIEEE Transactions on Magnetics, 1974
- Suppression of hard bubbles in magnetic garnet films by ion implantation: Dependence on ion species, dose, energy, and annealingApplied Physics Letters, 1973
- Storage hierarchies: Gaps, cliffs, and trendsIEEE Transactions on Magnetics, 1971