Development of stress birefringence and flow patterns during mold fillin and cooling
- 1 February 1978
- journal article
- Published by Wiley in Polymer Engineering & Science
- Vol. 18 (3), 173-179
- https://doi.org/10.1002/pen.760180302
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Jetting phenomena in injection mold filling mold fillingPolymer Engineering & Science, 1976
- The fluid mechanics and heat transfer of injection mold filling of thermoplastic materialsAIChE Journal, 1976
- Measurement of stress birefringence patterns in molten polymers flowing through geometrically complex channelsJournal of Applied Polymer Science, 1975
- Stress birefringence patterns in molten polymers during the mold-filling and cooling processJournal of Applied Polymer Science, 1974
- A special mold and tracer technique for studying shear and extensional flows in a mold cavity during injection moldingPolymer Engineering & Science, 1974
- Flow visualization for injection molding of polyethylene and polystyrene meltsPolymer Engineering & Science, 1974
- Studies of converging flows of viscoelastic polymeric melts. I. Stress-birefringent measurements in the entrance region of a sharp-edged slit dieJournal of Applied Polymer Science, 1973
- Some aspects of orientation in injection molded objectsPolymer Engineering & Science, 1972
- The injection molding of thermoplastics part II: Experimental test of the modelPolymer Engineering & Science, 1972
- Some flow phenomena in the injection molding of polystyreneJournal of Colloid Science, 1951