Design considerations for direct-conversion receivers
- 1 June 1997
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing
- Vol. 44 (6), 428-435
- https://doi.org/10.1109/82.592569
Abstract
No abstract availableThis publication has 14 references indexed in Scilit:
- Sensitivity simulation results for a direct-conversion FSK receiverPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Adaptive DC-offset compensation algorithm for burst mode operated direct conversion receiversPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- A 1.5 V 900 MHz downconversion mixerPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Design study on a direct conversion receiver front-end for 280 MHz, 900 MHz, and 2.6 GHz band radio communication systemsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- An integrated Si bipolar RF transceiver for a zero IF 900 MHz GSM digital mobile radio frontend of a hand portable phonePublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- A single-chip 900 MHz CMOS receiver front-end with a high performance low-IF topologyIEEE Journal of Solid-State Circuits, 1995
- Direct-conversion radio transceivers for digital communicationsIEEE Journal of Solid-State Circuits, 1995
- A 900 MHz transceiver chip set for dual-mode cellular radio mobile terminalsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1993
- Adaptive compensation for imbalance and offset losses in direct conversion transceiversIEEE Transactions on Vehicular Technology, 1993
- A single-chip VHF and UHF receiver for radio pagingIEEE Journal of Solid-State Circuits, 1991