The influence of age-hardening on turning and milling performance of Ti–Al–N coated inserts
- 29 May 2008
- journal article
- Published by Elsevier in Surface and Coatings Technology
- Vol. 202 (21), 5158-5161
- https://doi.org/10.1016/j.surfcoat.2008.05.036
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- A comparative research on physical and mechanical properties of (Ti, Al)N and (Cr, Al)N PVD coatings with high Al contentInternational Journal of Refractory Metals and Hard Materials, 2007
- Energetic balance and kinetics for the decomposition of supersaturated Ti1−xAlxNActa Materialia, 2006
- Impact of annealing on microstructure, properties and cutting performance of an AlTiN coatingSurface and Coatings Technology, 2006
- Mechanical properties and machining performance of Ti1−xAlxN-coated cutting toolsSurface and Coatings Technology, 2005
- A new low-friction concept for Ti1−xAlxN based coatings in high-temperature applicationsSurface and Coatings Technology, 2004
- Single layer and multilayer wear resistant coatings of (Ti,Al)N: a reviewMaterials Science and Engineering: A, 2003
- Hardness to toughness relationship of fine-grained WC-Co hardmetalsInternational Journal of Refractory Metals and Hard Materials, 1998
- Wear of cemented carbide cutting inserts with multilayer Ti-based PVD coatingsSurface and Coatings Technology, 1992
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- Attempt to Design a Strong SolidPhysical Review B, 1970