Correlation of the electrical properties of metal contacts on diamond films with the chemical nature of the metal-diamond interface. II. Titanium contacts: A carbide-forming metal
- 15 May 1992
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review B
- Vol. 45 (20), 11975-11981
- https://doi.org/10.1103/physrevb.45.11975
Abstract
The I-V characteristics of titanium contacts on polycrystalline diamond have been correlated with x-ray-photoelectron-spectroscopy (XPS) and Auger-electron-spectroscopy (AES) characterizations of the interface. As-deposited titanium contacts were rectifying in nature because of minimal interaction between as-deposited titanium and diamond as confirmed via XPS and AES. Once annealed, however, these contacts became Ohmic. The change was related to the formation of a carbide at the interface as observed by XPS. The Schottky-barrier height of the titanium contacts, which was determined by valence-band XPS, decreased from 1.3 to 0.8 eV as a result of the postdeposition annealing. It is believed that the carbide formation at the interface creates a diamond surface layer rich in electrically active defects which lower the barrier height of the metal and increase the leakage current. The interface between titanium and an argon-sputtered diamond surface was also characterized. Titanium formed as-deposited Ohmic contacts on the sputtered surface. A high density of ion-radiation-induced defects and a formation of a carbide during deposition both contributed to the Ohmic-contact formation. These contacts remained Ohmic after postdeposition annealing despite the fact that the annealing did not increase the carbide formed at the interface. It is believed that the carbide formed by the deposition of titanium behaved as a diffusion barrier to prevent the damaged layer from being annealed out into the titanium overlayer. It is concluded that most materials will yield rectifying contacts on a clean diamond surface. Ohmic contacts can be obtained by modifying the interface in some way (i.e., carbide formation, sputtering, etc.).Keywords
This publication has 24 references indexed in Scilit:
- Correlation of the electrical properties of metal contacts on diamond films with the chemical nature of the metal-diamond interface. I. Gold contacts: A non-carbide-forming metalPhysical Review B, 1992
- Characterization of ion beam-induced surface modification of diamond films by real time spectroscopic ellipsometryJournal of Vacuum Science & Technology A, 1991
- Ohmic contacts formed by ion mixing in the Si-diamond systemIEEE Transactions on Electron Devices, 1989
- Electrical Characteristics of Metal Contacts to Boron-Doped Diamond Epitaxial FilmJapanese Journal of Applied Physics, 1989
- Characterization of diamond thin films: Diamond phase identification, surface morphology, and defect structuresJournal of Materials Research, 1989
- Electronic structure of supported small metal clustersPhysical Review B, 1983
- X-ray photoelectron spectrum and band structure of TiCPhysical Review B, 1975
- The C-V characteristics of Schottky barriers on laboratory grown semiconducting diamondsSolid-State Electronics, 1973
- Some Aspects of ESCA Spectra of Single Crystals and Thin Films of Titanium CarbideJapanese Journal of Applied Physics, 1973
- Charge transfer in transition metal carbides and related compounds studied by ESCAJournal of Physics and Chemistry of Solids, 1969