Tolerance Chain Detection by Geometrical Constraint Based Coupling Analysis
- 1 March 1999
- journal article
- research article
- Published by Taylor & Francis in Journal of Engineering Design
- Vol. 10 (1), 5-24
- https://doi.org/10.1080/095448299261399
Abstract
Assembly tolerance chains are often the root cause for low geometrical robustness and high manufacturing costs. This paper presents a framework for function means modeling in configuration design that allows for modeling and analysis of geometrical couplings, and detection of potential tolerance chains. Requirement decomposition is described, and geometrical couplings on different hierarchical assembly levels are modeled, analyzed and explained. The treatment of sub-assemblies is especially described. The presented framework includes the use of locating schemes for positioning parts in assemblies. A general positioning system for modeling datum frames and locating schemes for parts and sub-assemblies are presented and used. An automotive example is used to show how an overall geometrical product constraint is decomposed into locating schemes on individual parts and how potential tolerance chains are detected. Finally, geometrical coupling quantification and the use of fixtures as a mean for breaking tolerance chains are discussed. The proposed framework enables potential tolerance chains to be detected already in the configuration design phase. By detecting potential tolerance chains in very early configuration design, design solutions with low robustness, needing tight tolerances to fulfill their functional requirements, may be avoided.Keywords
This publication has 17 references indexed in Scilit:
- Optimization of an Electrical Interconnect System Using Axiomatics and Fuzzy SetsJournal of Engineering Design, 1997
- A Variant Approach to Product Definition by Recognizing Functional Requirement PatternsJournal of Engineering Design, 1997
- Review of statistical approaches to tolerance analysisComputer-Aided Design, 1995
- Axiomatic approach to structural designResearch in Engineering Design, 1992
- A survey of research in the application of tolerance analysis to the design of mechanical assembliesResearch in Engineering Design, 1991
- Optimum Selection of Discrete TolerancesJournal of Mechanical Design, 1989
- Assessment and optimization of dimensional tolerancesComputer-Aided Design, 1985
- Allocation of Tolerances to Minimize Cost of AssemblyJournal of Engineering for Industry, 1973
- Calculation of Tolerance Based on a Minimum Cost ApproachJournal of Engineering for Industry, 1972
- The application of probability to tolerances used in engineering designsProceedings of the Institution of Mechanical Engineers, 1963