Development of density distributions in injection molded amorphous engineering plastics. Part II
- 1 February 1991
- journal article
- Published by Wiley in Polymer Engineering & Science
- Vol. 31 (3), 153-160
- https://doi.org/10.1002/pen.760310303
Abstract
No abstract availableKeywords
This publication has 30 references indexed in Scilit:
- Microstructure and ultimate properties of injection molded amorphous engineering plastics: Poly(ether imide) and poly(2,6‐dimethyl‐1,4‐phenylene ether)Polymer Engineering & Science, 1989
- Volumetric effects in the injection molding of polymersPolymer Engineering & Science, 1985
- Stress optical behavior in polystyrene; residual stresses and birefringences in large, quenched samplesJournal of Applied Polymer Science, 1983
- Residual stresses in polymers. II. Their effect on mechanical behaviorPolymer Engineering & Science, 1981
- Orientation effects and cooling stresses in amorphous polymersPolymer Engineering & Science, 1978
- Morphological zones and orientation in injection‐molded polyethyleneJournal of Applied Polymer Science, 1978
- Stress and Volume Relaxation in Annealing Flat GlassJournal of the American Ceramic Society, 1970
- Calculation of Residual Stresses in GlassJournal of the American Ceramic Society, 1969
- Time-temperature superposition and relaxational behavior in polymeric glassesJournal of Macromolecular Science, Part B, 1968
- The irreversible approach to equilibrium in glassesProceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences, 1953