Condensation Flow Mechanisms in Microchannels: Basis for Pressure Drop and Heat Transfer Models
- 1 April 2004
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 25 (3), 104-116
- https://doi.org/10.1080/01457630490280489
Abstract
This paper presents an overview of the use of flow visualization in micro- and mini-channel geometries for the development of pressure drop and heat transfer models during condensation of refrigerants. Condensation flow mechanisms for round, square, and rectangular tubes with hydraulic diameters in the range of 1–5 mm for 0 < x < 1, and 150 kg/m2-s and 750 kg/m2-s were recorded using unique experimental techniques that permit flow visualization during the condensation process. The effect of channel shape and miniaturization on the flow regime transitions was documented. The flow mechanisms were categorized into four different flow regimes: intermittent flow, wavy flow, annular flow, and dispersed flow. These flow regimes were further subdivided into several flow patterns within each regime. It was observed that the intermittent and annular flow regimes become larger as the tube hydraulic diameter is decreased, and at the expense of the wavy flow regime. These maps and transition lines can be used to predict the flow regime or pattern that will be established for a given mass flux, quality, and tube geometry. These observed flow mechanisms, together with pressure drop measurements, are being used to develop experimentally validated models for pressure drop during condensation in each of these flow regimes for a variety of circular and noncircular channels with 0.4 < Dh < 5 mm. These flow regime-based models yield substantially better pressure drop predictions than the traditionally used correlations that are primarily based on air-water flows for large diameter tubes. Condensation heat transfer coefficients were also measured using a unique thermal amplification technique that simultaneously allows for the accurate measurement of the low heat transfer rates over small increments of refrigerant quality and high heat transfer coefficients characteristic of microchannels. Models for these measured heat transfer coefficients are being developed using the documented flow mechanisms and the corresponding pressure drop models as the basis.Keywords
This publication has 16 references indexed in Scilit:
- Two-phase flow regimes in round, square and rectangular tubes during condensation of refrigerant R134aInternational Journal of Refrigeration, 2002
- An Experimentally Validated Model for Two-Phase Pressure Drop in the Intermittent Flow Regime for Circular MicrochannelsJournal of Fluids Engineering, 2001
- Characterization of two-phase flow patterns in small diameter round and rectangular tubesInternational Journal of Heat and Mass Transfer, 1999
- Two-phase flow regimes in narrow rectangular vertical and horizontal channelsInternational Journal of Heat and Mass Transfer, 1994
- Determination and Characteristics of the Transition to Two-Phase Slug Flow in Small Horizontal ChannelsJournal of Fluids Engineering, 1994
- Two-phase flow patterns and transitions in a small, horizontal, rectangular channelInternational Journal of Multiphase Flow, 1991
- Flow pattern in horizontal and vertical two phase flow in small diameter pipesThe Canadian Journal of Chemical Engineering, 1983
- Effects of fluid properties and pipe diameter on two-phase flow patterns in horizontal linesInternational Journal of Multiphase Flow, 1979
- A model for predicting flow regime transitions in horizontal and near horizontal gas‐liquid flowAIChE Journal, 1976
- A flow pattern map for gas—liquid flow in horizontal pipesInternational Journal of Multiphase Flow, 1974