Elastomers in metal forming: A review
- 1 October 1993
- journal article
- review article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 39 (1-2), 55-82
- https://doi.org/10.1016/0924-0136(93)90008-t
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- An exploration of the piercing of round holes in metal sheets in the presence of frictionally induced radial compressive stressJournal of Materials Processing Technology, 1990
- Tube bulging with a urethane rodJournal of Materials Processing Technology, 1990
- Free forming of near-hemispherical shells using a urethane padJournal of Materials Processing Technology, 1989
- Friction-actuated blank holding in deep drawingJournal of Materials Processing Technology, 1988
- Unconventional Tee Forming on Metal TubesJournal of Engineering for Industry, 1985
- Attempts to facilitate low volume production of soft aluminium cups with large drawing ratios by deep drawing based on Maslennikov's techniqueJournal of Materials Processing Technology, 1979
- On the mechanics of sheet-metal bending with confined compressible diesJournal of Materials Processing Technology, 1978
- Deep Drawing of Circular Sheet Metals with Rubber Rings : 3rd Report, On the Drawing MechanismBulletin of JSME, 1974
- Deep Drawing of Circular Sheet Metals with Rubber Rings : 1st Report, The Case of First Drawing OperationBulletin of JSME, 1972
- PIERCING OF METAL SHEET WITH RUBBER PADSInternational Journal of Production Research, 1967