Determination of Optimal Parameters for SKD11 CNC Turning Process
- 4 April 2008
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 23 (4), 363-368
- https://doi.org/10.1080/10426910801937975
Abstract
This study investigated the optimization of a CNC turning process for SKD11 (JIS). The design of experiments (DOE) method with an orthogonal array was applied. Nine experimental runs were performed based on the orthogonal array. The surface properties of roughness average and roughness maximum and the roundness were studied; the analysis of variance (ANOVA) was adapted to investigate which parameters had the most influence on the CNC turning process for SKD11 (JIS). Also, models for predictions of the roughness average, roughness maximum, and roundness had been developed in terms of cutting speed, feed rate, depth of cut, and the mixture ratio of cutting fluids.Keywords
This publication has 10 references indexed in Scilit:
- Optimization of Injection-Molding Process of Short Glass Fiber and Polytetrafluoroethylene Reinforced Polycarbonate Composites via Design of Experiments Method: A Case StudyMaterials and Manufacturing Processes, 2006
- Optimization of a photo resists coating process for photolithography in wafer manufacturing via design of experiments methodMicroelectronics International, 2006
- A technical note on the role of process parameters in predicting flow behavior of plasticine using design of experimentJournal of Materials Processing Technology, 2006
- Design optimization of cutting parameters when turning hardened AISI 4140 steel (63 HRC) with Al2O3+TiCN mixed ceramic toolMaterials & Design (1980-2015), 2006
- Application of Taguchi method in the optimization of cutting parameters for surface roughness in turningMaterials & Design (1980-2015), 2006
- Optimization of Grinding Process Through Design of Experiment (DOE)—A Comparative StudyMaterials and Manufacturing Processes, 2006
- A Study of Optimization of Machining Parameters for Electrical Discharge Machining of Boron CarbideMaterials and Manufacturing Processes, 2004
- Investigation for optimal parametric combination for achieving better surface finish during turning of Al/SiC-MMCThe International Journal of Advanced Manufacturing Technology, 2004
- Design optimization of cutting parameters for turning operations based on the Taguchi methodJournal of Materials Processing Technology, 1998
- Cutting fluids: Part I. CharacterisationJournal of Materials Processing Technology, 1996