The effect of temperature on the delayed yield and failure of “plasticized” epoxy resin
- 1 March 1969
- journal article
- Published by Wiley in Polymer Engineering & Science
- Vol. 9 (2), 131-140
- https://doi.org/10.1002/pen.760090209
Abstract
No abstract availableKeywords
This publication has 22 references indexed in Scilit:
- The modulus and yield stress of glassy poly(methyl methacrylate) at strain rates up to 103 inch/inch/secondJournal of Applied Polymer Science, 1968
- Delayed yielding of epoxy resin under tension, compression, and flexure. I. Behavior under constant strain rateJournal of Applied Polymer Science, 1967
- Cold flow of glassy polymers. I. Effect of internal stressJournal of Polymer Science Part B: Polymer Letters, 1967
- Cold Drawing of Glassy Polystyrene under Dead LoadJournal of Applied Physics, 1965
- Ultimate Tensile Properties of Elastomers. II. Comparison of Failure Envelopes for Unfilled VulcanizatesJournal of Applied Physics, 1964
- Time and Temperature Dependence of the Ultimate Properties of an SBR Rubber at Constant ElongationsJournal of Applied Physics, 1960
- Dependence of the ultimate properties of a GR‐S rubber on strain rate and temperatureJournal of Polymer Science, 1958
- Tensile Strength of Plastics below the Glass TemperatureJournal of Applied Physics, 1957
- Elastoviscous properties of polyisobutylene. V. The transition regionJournal of Polymer Science, 1952
- Creep and Damping Properties of PolystyreneJournal of Applied Physics, 1949