Transition from Thermal to Athermal Friction under Cryogenic Conditions
- 5 May 2009
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 102 (18), 186102
- https://doi.org/10.1103/physrevlett.102.186102
Abstract
Atomic scale frictional forces encountered as a function of temperature for the contact of a probe tip and the basal plane of have been measured with atomic force microcopy over the temperature range 100–500 K. Friction is observed to increase exponentially with decreasing temperature from 500 to 220 K. An Arrhenius analysis of the temperature dependent friction over this range yields an effective activation energy of for the thermally activated stick-slip motion of the probe tip on this surface. As temperature is reduced further below 220 K, a distinct transition to a largely athermal behavior is detected and is shown to result from the onset of interfacial wear, entailing an alternative energy dissipation pathway.
Keywords
This publication has 22 references indexed in Scilit:
- Temperature Dependence of Single-Asperity Diamond−Diamond Friction Elucidated Using AFM and MD SimulationsThe Journal of Physical Chemistry C, 2008
- Temperature dependence of friction under cryogenic conditions in vacuumTribology Letters, 2006
- Temperature dependence of point contact friction on siliconApplied Physics Letters, 2006
- Cryogenic Friction Behavior of PTFE based Solid Lubricant CompositesTribology Letters, 2005
- Thermally induced suppression of friction at the atomic scalePhysical Review E, 2005
- Interaction Potential and Hopping Dynamics Governing Sliding FrictionPhysical Review Letters, 2003
- Friction and wear of PTFE composites at cryogenic temperaturesTribology International, 2002
- Thermal Effects on Atomic FrictionPhysical Review Letters, 2001
- Velocity Dependence of Atomic FrictionPhysical Review Letters, 2000
- Tribological behaviour of materials at cryogenic temperaturesWear, 1998