Properties of the voltage‐dependent calcium channel of mouse Swiss 3T3 fibroblasts.
- 30 June 1988
- journal article
- research article
- Published by Wiley in The Journal of Physiology
- Vol. 401 (1), 639-655
- https://doi.org/10.1113/jphysiol.1988.sp017184
Abstract
1. Suspended Swiss 3T3 fibroblasts were voltage clamped using the whole-cell technique. 2. Passage from the cell-attached to the whole-cell mode was accompanied by only a minor decrease in input resistance. Direct measurement of resting potential gave values between 0 and -15 mV. 3. In order to account for the effects of leak on the membrane potential measurements, I-V curves were obtained immediately before and after patch rupture by applying voltage ramps. After subtraction of the cell-attached current from the whole-cell current, the true membrane potential was estimated as the zero-current potential in the I-V curve. An average value of -8.2 .+-. 0.9 mV in 8 mM-Ca2+ was obtained in this way. 4. In 2 mM-Ca2+, step depolarization 100 ms long from hold potentials (Vh) more negative than -60 mV caused a transient inward current to appear. From Vh > -60 mV only a linear leakage component was apparent. 5. In 2 mM-Ca2+ depolarizations to potentials > + 40 mV (from Vh = -100 mV) generated transient, outwardly directed currents. 6. Increasing extracellular Ca2+ up to 32 mM shifted the peak current vs. voltage curve and the reversal potential (Erev) towards more positive potentials, and caused an increase of the peak current. 7. The steady-state inactivation curve was the same for both inward and outward currents, indicating that they flow through the same channels. The currents are completely inactivated that they flow through the same channels. The currents are completely inactivated at V = -60 mV. 8. Recovery of the fully inactivated current upon hyperpolarization had an exponential time course with .tau. = 0.22 s at V = -80 mV and .tau. = 0.18 s at V = -100 mV. 9. In the absence of Ca2+ (but with Mg2+ present) the inward current disappeared but a large, inactivating outward current appeared when V > 0 mV. The current was strongly reduced by Cd2+ (1 mM) or Co2+ (10 mM). 10. Complete removal of divalent cations from the external solution caused the channel to become highly permeable to monovalent cations. 11. Nitrendipine (10 .mu.M) and verapamil (5 .mu.M) were unable to block the current. 12. On the whole the present results indicate that voltage-dependent Ca2+ channels are present in these cells. Their sensitivity to divalent cations, to organic blockers and to potential is similar to that of the low-voltage-activated, or ''T'' type, Ca2+ channels described in other cells.This publication has 25 references indexed in Scilit:
- The calcium current of mouse egg measured in physiological calcium and temperature conditions.The Journal of Physiology, 1987
- Inositol trisphosphate, a novel second messenger in cellular signal transductionNature, 1984
- Reduction of epidermal growth factor receptor affinity by heterologous ligands: Evidence for a mechanism involving the breakdown of phosphoinositides and the activation of protein kinase CBiochemical and Biophysical Research Communications, 1984
- A low voltage-activated, fully inactivating Ca channel in vertebrate sensory neuronesNature, 1984
- Oscillatory hyperpolarizations and resting membrane potentials of mouse fibroblast and macrophage cell lines.The Journal of Physiology, 1984
- Epidermal growth factor induces electrically silent Na+ influx in human fibroblasts.Journal of Biological Chemistry, 1982
- Cell surface molecules and fibronectin-mediated cell adhesion: effect of proteolytic digestion of membrane proteins.The Journal of cell biology, 1982
- Calcium channel and calcium pump involved in oscillatory hyperpolarizing responses of L‐strain mouse fibroblastsThe Journal of Physiology, 1982
- Oscillations of membrane potential in L cellsThe Journal of Membrane Biology, 1979
- An Active Electrical Response in FibroblastsThe Journal of general physiology, 1972