Factors controlling the abrasive wear response of a zinc-based alloy silicon carbide particle composite
- 31 December 1997
- journal article
- Published by Elsevier in Composites Part A: Applied Science and Manufacturing
- Vol. 28 (4), 301-308
- https://doi.org/10.1016/s1359-835x(96)00115-7
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Abrasive Wear Characteristics of Zn–37.2Al–2.5Cu–0.2Mg Alloy Dispersed with Silicon Carbide ParticlesMaterials Transactions, JIM, 1995
- Mechanisms of material removal and subsurface work hardening during low-stress abrasion of a squeeze-cast aluminium alloy-Al2O3 fibre compositeMaterials Science and Engineering: A, 1992
- Effects of dislodgment and size of abrasive grains on abrasive wearWear, 1992
- Abrasion-induced microstructural changes and material removal mechanisms in squeeze-cast aluminium alloy-silicon carbide compositesJournal of Materials Science, 1992
- ZnAl matrix composites: investigation of the thermal expansion, creep resistance and fracture toughnessMaterials Science and Engineering: A, 1991
- Wear resistance and microstructure of Zn-Al-Si and Zn-Al-Cu alloysWear, 1987
- Mechanical properties and lubricated wear of Zn-25Al-based alloysWear, 1987
- Comparative wear behaviour of Zn-Al-based alloys in an automotive engine applicationWear, 1984
- Effects of grit size on abrasion with coated abrasivesWear, 1976
- Brittleness as an indentation size effectJournal of Materials Science, 1976