A urethane clamp as a metal-forming tool
- 31 May 1993
- journal article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 38 (3), 491-500
- https://doi.org/10.1016/0924-0136(93)90065-e
Abstract
No abstract availableKeywords
This publication has 14 references indexed in Scilit:
- A theory for the bulging of aluminium tubes using a urethane rodJournal of Materials Processing Technology, 1994
- Deep drawing of cylindrical cups with friction-actuated blank holdingJournal of Materials Processing Technology, 1994
- An exploration of the piercing of round holes in metal sheets in the presence of frictionally induced radial compressive stressJournal of Materials Processing Technology, 1990
- Tube bulging with a urethane rodJournal of Materials Processing Technology, 1990
- Deep Drawing With Blank Holder Force Approximately Proportional to the Punch ForceJournal of Engineering for Industry, 1990
- Friction-actuated blank holding in deep drawingJournal of Materials Processing Technology, 1988
- Unconventional Tee Forming on Metal TubesJournal of Engineering for Industry, 1985
- Attempts to facilitate low volume production of soft aluminium cups with large drawing ratios by deep drawing based on Maslennikov's techniqueJournal of Materials Processing Technology, 1979
- On the mechanics of sheet-metal bending with confined compressible diesJournal of Materials Processing Technology, 1978
- PIERCING OF METAL SHEET WITH RUBBER PADSInternational Journal of Production Research, 1967