Small circular and noncircular channels are representative of flow passages act evaporators and condensers. This report describes results of an ental study on heat transfer to the flow boiling of refrigerants (R-12) and refrigerant-134a (R-134a) in a small horizontal circular-cross-section tube. The tube diameter of 2.46 mm was chosen to approximate the hydraulic diameter of a 4.06 {times} 1.70 mm rectangular channel previously studied with R-12, and a 2.92-mm-diameter circular tube previously studied with R-113. The objective of this study was to assess the effects of channel geometry and fluid properties on the heat transfer coefficient and to obtain additional insights relative to the heat transfer mechanism(s). The current circular flow channel for the R-12 and R-134a tests was made of brass and had an overall length of 0.9 in. The channel wall was electrically heated, and thermocouples were installed on the channel wall and in the bulk fluid stream. Voltage taps were located at the same axial locations as the stream thermocouples to allow testing over an exit quality range to 0.94 and a large range of mass flux (58 to 832 kg/m{sup 2}s) and heat flux (3.6 to 59 kW/m{sup 2}). Saturation pressure was nearly constant, averaging 0.82more » MPa for most of the testing, with some tests performed at a lower pressure of 0.4--0.5 MPa. Local heat transfer coefficients were determined experimentally as a function of quality along the length of the test section. Analysis of all data for three tubes and three fluids supported the conclusion that a nucleation mechanism dominates for flow boiling in small channels. Nevertheless, a convection-dominant region was obtained experimentally in this study at very low values of wall superheat (< {approx} 2.75{degrees}C). The circular and rectangular tube data for three fluids were successfully correlated in the nucleation-dominant region. « less