Moments and power generated by the horse (Equus caballus) hind limb during jumping
- 1 February 2004
- journal article
- research article
- Published by The Company of Biologists in Journal of Experimental Biology
- Vol. 207 (4), 667-674
- https://doi.org/10.1242/jeb.00808
Abstract
SUMMARY The ability to jump over an obstacle depends upon the generation of work across the joints of the propelling limb(s). The total work generated by one hind limb of a horse and the contribution to the total work by four joints of the hind limb were determined for a jump. It was hypothesized that the hip and ankle joints would have extensor moments performing positive work, while the knee would have a flexor moment and perform negative work during the jump. Ground reaction forces and sagittal plane kinematics were simultaneously recorded during each jumping trial. Joint moment, power and work were determined for the metatarsophalangeal (MP), tarsal (ankle), tibiofemoral (knee) and coxofemoral (hip) joints. The hip, knee and ankle all flexed and then extended and the MP extended and then flexed during ground contact. Consistent with our hypothesis, large extensor moments were observed at the hip and ankle joints and large flexor moments at the knee and MP joints throughout ground contact of the hind limb. Peak moments tended to occur earlier in stance in the proximal joints but peak power generation of the hind limb joints occurred at similar times except for the MP joint, with the hip and ankle peaking first followed by the MP joint. During the first portion of ground contact (≈40%), the net result of the joint powers was the absorption of power. During the remainder of the contact period, the hind limb generated power. This pattern of power absorption followed by power generation paralleled the power profiles of the hip, ankle and MP joints. The total work performed by one hind limb was 0.71 J kg-1. Surprisingly, the knee produced 85% of the work (0.60 J kg-1) done by the hind limb, and the positive work performed by the knee occurred during the first 40% of the take-off. There is little net work generated by the other three joints over the entire take-off. Velocity of the tuber coxae (a landmark on the pelvis of the animal) was negative (downward) during the first 40% of stance, which perhaps reflects the negative work performed to decrease the potential energy during the first 40% of contact. During the final 60% of contact, the hip, ankle and MP joints generate positive work, which is reflected in the increase of the animal9s potential energy.This publication has 10 references indexed in Scilit:
- The effect of gait and digital flexor muscle activation on limb compliance in the forelimb of the horseEquus caballusJournal of Experimental Biology, 2003
- Muscle Functionin vivo: A Comparison of Muscles used for Elastic Energy SavingsversusMuscles Used to Generate Mechanical Power1American Zoologist, 1998
- Inertial properties of Dutch Warmblood horsesJournal of Biomechanics, 1997
- Analysis of the equine jumping technique by accelerometryEquine Veterinary Journal, 1997
- The control of mono‐articular muscles in multijoint leg extensions in man.The Journal of Physiology, 1995
- Kinematics of the hind limb push‐off in elite show jumping horsesEquine Veterinary Journal, 1994
- The Global Design of the Hindlimb in QuadrupedsCells Tissues Organs, 1993
- Correction models for skin displacement in equine kinematics gait analysisJournal of Equine Veterinary Science, 1992
- The constrained control of force and position in multi-joint movementsNeuroscience, 1992
- Mechanics of locomotion and jumping in the horse (Equus): in vivo stress in the tibia and metatarsusJournal of Zoology, 1988