Mechanics of Orthogonal Machining
- 1 June 1959
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers
- Vol. 173 (1), 623-654
- https://doi.org/10.1243/pime_proc_1959_173_053_02
Abstract
In an attempt to overcome the deficiencies of existing theories of cutting, an experimental technique was developed for observing the cutting process during slow orthogonal cutting of mild steel. An attempt to find consistency between the observations and the ideal theory of plasticity failed. Consequently the theory was extended by including the effect of work- hardening and, in spite of the laborious nature of the analysis, it appeared that consistency had been regained. This led to a novel and physically consistent picture of the cutting process, which was taking place during the tests.Keywords
This publication has 13 references indexed in Scilit:
- Shear-Zone Temperature in Metal Cutting and Its Effects on Shear-Flow StressTransactions of the American Society of Mechanical Engineers, 1958
- Shear-Strain Rate in Metal Cutting and Its Effects on Shear-Flow StressTransactions of the American Society of Mechanical Engineers, 1958
- The mechanics of machining: A new approachJournal of the Mechanics and Physics of Solids, 1954
- Some Observations on Chip Curl in the Metal-Cutting Process Under Orthogonal Cutting ConditionsTransactions of the American Society of Mechanical Engineers, 1953
- Deformation Work Absorbed by the Workpiece During Metal CuttingTransactions of the American Society of Mechanical Engineers, 1953
- The Shear-Angle Relationship in Metal CuttingTransactions of the American Society of Mechanical Engineers, 1953
- The Theory of Plasticity Applied to a Problem of MachiningJournal of Applied Mechanics, 1951
- Residual Stresses in Machined SurfacesTransactions of the American Society of Mechanical Engineers, 1951
- The Flow of Metals under Various Stress ConditionsProceedings of the Institution of Mechanical Engineers, 1947
- Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 ChipJournal of Applied Physics, 1945