Lateral ridge augmentation by the use of grafts comprised of autologous bone or a biomaterial. An experiment in the dog

Abstract
Objective: The present investigation was performed to determine if a block of Bio‐Oss® used as an onlay graft can be used as a scaffold for new bone formation. Material and methods: Five mongrel dogs were used. The mandibular premolars were extracted. On both sides of the mandible, the buccal bone plate was resected and defects, about 25 mm long, 8 mm high and 5 mm wide, were produced After 3 months of healing, a second surgical procedure was performed. In the left side, a block of Bio‐Oss® was adjusted to the buccal bone wall. The graft had the shape of a cylinder and was retained with a miniscrew and covered with a collagen membrane. In the contra‐lateral side of the mandible, a block biopsy was first obtained from the ascending ramus. This bone graft had the shape of a cylinder that was 8 mm in diameter and 3 mm thick. The graft was transferred to the experimental site, adjusted to the buccal wall, retained with a miniscrew, and covered with a membrane. The flaps were repositioned and closed with sutures to ensure a complete coverage of the experimental sites. After 6 months of healing, the dogs were sacrificed and the experimental sites dissected. The biopsies were processed for ground sectioning. The sections were stained in toluidine blue, examined in the microscope, and a number of histo‐ and morphometric assessments made. Results: The study demonstrated that cortical bone used as an onlay graft in the lateral aspect of the alveolar ridge, during a 6‐month period of healing integrated with the host bone but underwent marked peripheral resorption. Thus, close to 30% of the height and 50% of the length of the graft was replaced with connective tissue. It was further observed that while the dimensions of a graft which contained a scaffold of cancellous bovine bone mineral remained unchanged, only moderate amounts of new bone formed at the base of this graft. Conclusion: Grafts of autologous cortical bone, placed on the surface of a one‐wall defect, may undergo marked resorption during healing. A similar graft of Bio‐Oss® may retain its dimension, and limited amounts of new bone will form within the biomaterial.