Influence of glass fibers on the extrusion and injection molding characteristics of polyethylene and polystyrene melts
- 1 March 1978
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 18 (4), 268-272
- https://doi.org/10.1002/pen.760180406
Abstract
No abstract availableKeywords
This publication has 24 references indexed in Scilit:
- Extrudate swell during the melt spinning of fibers—influence of rheological properties and take-up forcesJournal of Applied Polymer Science, 1977
- Extrudate swell during the melt spinning of fibers—influence of rheological properties and take-up forceJournal of Applied Polymer Science, 1976
- Tensile stress contribution of flow-oriented slender particles in non-newtonian fluidsJournal of Non-Newtonian Fluid Mechanics, 1976
- Flow of short glass fibre-filled polymer meltsFibre Science and Technology, 1974
- On Silt- and Capillary-Die RheometryTransactions of the Society of Rheology, 1974
- Theory for normal stresses in slits and capillariesJournal of Physics D: Applied Physics, 1973
- Polymer Melt Flow Instabilities in Extrusion: Investigation of the Mechanism and Material and Geometric VariablesTransactions of the Society of Rheology, 1971
- Rheological Implications of the Exit Pressure and Die Swell in Steady Capillary Flow of Polymer Melts. I. The Primary Normal Stress Difference and the Effect of L/D Ratio on Elastic PropertiesTransactions of the Society of Rheology, 1970
- Surface fracture in injection molding of filled polymersPolymer Engineering & Science, 1970
- Capillary Rheometry as a Technique for Predicting Processing of ElastomersTransactions of the Society of Rheology, 1961