X-ray quantum limited portal imaging using amorphous silicon flat-panel arrays
- 1 May 1998
- journal article
- Published by Wiley in Medical Physics
- Vol. 25 (5), 689-702
- https://doi.org/10.1118/1.598252
Abstract
We have measured the linearity, spatial resolution (MTF), noise (NPS), and signal-to-noise characteristics (DQE) of an electronic portal imaging device (EPID) based on an amorphous silicon flat-panel array. The array has a 128 x 128-pixel matrix and each pixel is 0.75 x 0.75 mm2 in dimension so the array covers an area of 96 x 96 mm2. The array acts like a large area light sensor and records the optical signals generated in a metal plate/phosphor screen x-ray detector when the detector is irradiated by a megavoltage x-ray beam. In addition, approximately 0.5% of the total signal is generated by nonoptical processes. The noise measurements show that the device is quantum noise limited with the noise power generated by the x-ray quanta being up to 100 times greater than the noise added by the external readout electronics and flat-panel light sensor itself. However, the flat-panel light sensor does reduce the spatial resolution (compared to a perfect optical sensor with infinitesimal pixel size) because of its moderate pixel size and because optical spread can occur in the transparent glues used to attach the phosphor screen to the flat-panel light sensor. The response of the sensor is very linear and does not suffer from the glare phenomenon associated with TV camera-based EPIDs--characteristics which suggest that the amorphous silicon EPID will be well suited to transit dosimetry. Nevertheless, some limitations need to be overcome before these devices can be used clinically. These include developing larger flat-panel light sensors, the elimination of "noisy" pixels with high dark signal, and improvements in the uniform sensitivity of the sensors. This last requirement is only needed for transit dosimetry applications where it would greatly simplify calibration of the device. In addition, an image acquisition scheme must be developed to eliminate artifacts created by the pulsed x-ray beam generated by linear accelerators. Despite these limitations, our studies suggest that the amorphous silicon EPIDs are very well suited to portal imaging.Keywords
This publication has 54 references indexed in Scilit:
- Portal dose measurement in radiotherapy using an electronic portal imaging device (EPID)Physics in Medicine & Biology, 1995
- Tests for evaluating laser film digitizersMedical Physics, 1995
- Optimal radiographic magnification for portal imagingMedical Physics, 1994
- Photoresponse Linearity of a-Si:H Imaging PixelsMRS Proceedings, 1993
- Considerations for High Frame Rate Operation of Two-Dimensional a-Si:H Imaging ArraysMRS Proceedings, 1993
- Display equalization: A new display method for portal imagesMedical Physics, 1993
- Comparison of Computer Simulations with Measurements From a-Si:H Imaging Arrays.MRS Proceedings, 1992
- Development of hydrogenated amorphous silicon sensors for diagnostic X-ray imagingIEEE Transactions on Nuclear Science, 1991
- Light-Response Characteristics of Amorphous Silicon Arrays for Megavoltage and Diagnostic ImagingMRS Proceedings, 1991
- Investigation of basic imaging properties in digital radiography. 6. MTFs of II-TV digital imaging systemsMedical Physics, 1985