Glass fiber-filled thermoplastics. II. Cavity filling and fiber orientation in injection molding
- 1 November 1985
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 25 (16), 1008-1016
- https://doi.org/10.1002/pen.760251604
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- Influence of injection‐molding parameters on the morphology and mechanical properties of glass fiber‐reinforced polypropylene compositesPolymer Composites, 1982
- Behavior of discontinuous fiber composites: Fiber orientationPolymer Composites, 1982
- Shear flow rheological properties, fiber damage, and mastication characteristics of aramid‐, glass‐, and cellulose‐fiber‐reinforced polystyrene meltsJournal of Applied Polymer Science, 1980
- A finite-element/finite-difference simulation of the injection-molding filling processJournal of Non-Newtonian Fluid Mechanics, 1980
- A study of the effect of injection speed on fibre orientation in simple mouldings of short glass fibre-filled polypropyleneJournal of Materials Science, 1978
- Influence of glass fibers on the extrusion and injection molding characteristics of polyethylene and polystyrene meltsPolymer Engineering & Science, 1978
- Particle motions in non-newtonian mediaRheologica Acta, 1975
- Molecular orientation in injection moldingJournal of Applied Polymer Science, 1974
- The Thermal and Electrical Conductivity of Two-Phase SystemsIndustrial & Engineering Chemistry Fundamentals, 1974
- Dynamic mechanical properties of particulate‐filled compositesJournal of Applied Polymer Science, 1970