Structural properties of InN on GaN grown by metalorganic vapor-phase epitaxy
- 1 June 1999
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 85 (11), 7682-7688
- https://doi.org/10.1063/1.370571
Abstract
InN has been expected to be a suitable material for electronic devices such as high mobility transistors because of its small effective mass compared to other nitrides. Heteroepitaxial InN films were grown by metalorganic vapor-phase epitaxy. The films have been structurally characterized by triple-axis x-ray diffraction (XRD) analysis in terms of lattice-mismatch dependence and InN film thickness dependence, and Hall measurements have been performed. In the XRD measurement, ω and ω–2θ scans were used, and the degree of tilting (the linewidth of x-ray signal, Δωc) [(0002) reflection] and that of twisting (Δωa) [(101̄0) reflection] have been separated. In addition, the degree of distribution of lattice constant c (Δ2θc) [(0002) reflection] of InN films has been assessed. For study of the lattice-mismatch dependence, growth of InN films on GaN, AlN and directly on sapphire substrates was performed, and accordingly, Δωc was found to range from about 500 to 4000 arcsec, and Δ2θc from about 400 to 700 arcsec. Among those three kinds of samples, InN films grown on GaN showed the smallest Δωc and Δ2θc values. Observation of c- and a-lattice parameters has shown that the InN on GaN is affected by the residual strain. On the other hand, InN thickness dependence of XRD showed that Δωc was changed from about 700 to 500 arcsec, and Δ2θc from about 600 to 300 arcsec with increasing InN thickness from 400 to 2400 Å. In accordance with the thickness of InN, Δωa was found to change from about 2500 to 1700 arcsec. Moreover, it was found that the InN film less than 1200 Å thick is composed of grain islands with different crystalline orientation and that the growth mode changes at a thickness of about 1200 Å—and screw dislocations occur. It is found that the residual strain in InN films over 1200 Å thick is gradually released, resulting in almost the same orientation. This is reflected in the reduction of the mosaicity, the proceeding of relaxation and the surface morphology. Selection of GaN for the underlying layer of the InN film has been shown to lead to structural improvement of the epitaxial InN film. In fact, InN film with a thickness of 2400 Å grown on GaN has a Hall mobility of about 700 cm2/V s even at an electron carrier concentration of 5×1019 cm−3. This value corresponds to that for GaAs at the same impurity concentration.Keywords
This publication has 22 references indexed in Scilit:
- Optical Properties of Strained AlGaN and GaInN on GaNJapanese Journal of Applied Physics, 1997
- InGaN-Based Multi-Quantum-Well-Structure Laser DiodesJapanese Journal of Applied Physics, 1996
- Shortest wavelength semiconductor laser diodeElectronics Letters, 1996
- Structural properties of InN films grown on sapphire substrates by microwave-excited metalorganic vapor-phase epitaxyJournal of Applied Physics, 1994
- Thermal stability of indium nitride single crystal filmsJournal of Applied Physics, 1993
- Epitaxial growth of indium nitrideJournal of Crystal Growth, 1990
- Preparation and properties of III-V nitride thin filmsJournal of Applied Physics, 1989
- Heteroepitaxial growth of InN by microwave-excited metalorganic vapor phase epitaxyApplied Physics Letters, 1989
- Optical band gap of indium nitrideJournal of Applied Physics, 1986
- Electrical and Optical Properties of rf-Sputtered GaN and InNApplied Physics Letters, 1972