Noise in optical measurements of cantilever deflections
- 1 July 1998
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 84 (1), 58-63
- https://doi.org/10.1063/1.368001
Abstract
The optical beam deflection method using the knife edge detection technique is one of the simplest optical sensing methods. We investigate theoretically the limit to the resolution when sensing the displacements of a mechanical cantilever using the knife edge detection technique implemented with a quasimonochromatic thermal-like optical source. Simple formulas for the minimum detectable displacement of the cantilever’s front end are derived assuming all nonoptical noises negligible. It is shown that superluminiscent diodes can yield a minimum detectable displacement of the cantilever about 5 dBs above the shot noise for 1 mW of optical power. It is also shown that in many cases of practical interest the source induced noise is smaller than the thermal-vibration noise of the cantilever. Thus, in many cases, using an inexpensive thermal-like source with the knife edge detection technique can be as effective as using a high-coherence shot-noise limited source.Keywords
This publication has 13 references indexed in Scilit:
- Approach to improve the angle sensitivity and resolution of the optical beam deflection method using a passive interferometer and a Ronchi gratingOptical Engineering, 1997
- Multi-mode noise analysis of cantilevers for scanning probe microscopyJournal of Applied Physics, 1997
- Improvements to atomic force microscopy cantilevers for increased stabilityReview of Scientific Instruments, 1996
- Design of a ‘‘beetle-type’’ atomic force microscope using the beam deflection techniqueReview of Scientific Instruments, 1996
- A femtojoule calorimeter using micromechanical sensorsReview of Scientific Instruments, 1994
- Minimum detectable displacement in near-field scanning optical microscopyApplied Physics Letters, 1994
- Source-induced noise in optical systems driven by low-coherence sourcesJournal of Lightwave Technology, 1990
- An atomic-resolution atomic-force microscope implemented using an optical leverJournal of Applied Physics, 1989
- Erratum: Novel optical approach to atomic force microscopy [Appl. Phys. Lett. 5 3, 1045 (1988)]Applied Physics Letters, 1988
- Effect of carbon concentration on the thermal conversion of liquid-encapsulated Czochralski semi-insulating GaAsApplied Physics Letters, 1988