Design considerations for high-voltage high-power full-bridge zero-voltage-switched PWM converter
- 1 January 1990
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 275-284
- https://doi.org/10.1109/apec.1990.66420
Abstract
A steady-state analysis is presented with complete characterization of the converter operation. A small-signal model of the converter is established. The design procedures based on the analysis are presented and the various losses in the circuit assessed. Critical design considerations for a high-power, high-voltage application are analyzed. The results of the analysis are verified using a high-voltage. 2 kW prototype.<>Keywords
This publication has 5 references indexed in Scilit:
- A 1 kW, 500 kHz front-end converter for a distributed power supply systemPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Off-line application of the fixed frequency clamped mode series-resonant converterPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Zero-voltage-switching multi-resonant technique-a novel approach to improve performance of high frequency quasi-resonant convertersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- A zero-current-switched off-line quasi-resonant converter with reduced frequency range: analysis, design, and experimental resultsIEEE Transactions on Power Electronics, 1989
- Constant-frequency, clamped-mode resonant convertersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1987