On Hill's general method of analysis for metal-working processes
- 1 August 1974
- journal article
- Published by Elsevier in International Journal of Mechanical Sciences
- Vol. 16 (8), 521-540
- https://doi.org/10.1016/0020-7403(74)90018-6
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- An Analysis of Deformation Characteristics and Interfacial Friction Conditions in Simple Upsetting of RingsJournal of Engineering for Industry, 1972
- Influence of Flow Stress and Friction Upon Metal Flow in Upset Forging of Rings and CylindersJournal of Engineering for Industry, 1972
- On the Non-Uniform Deformation of Block in Plane-Strain Compression Caused by Friction : Part 1, Theoretical Analysis Using Calculus of VariationsBulletin of JSME, 1970
- An analysis of the changes in geometry of a short hollow cylinder during axial compressionInternational Journal of Mechanical Sciences, 1967
- Some Experimental Results Concerning Spread in the Rolling of LeadJournal of Basic Engineering, 1966
- A general method of analysis for metal-working processesJournal of the Mechanics and Physics of Solids, 1963
- Strain Rate Distribution During Experimental Metal RollingJournal of Engineering for Industry, 1962
- Theoretical Study of Tube Sinking through Conical DiesJournal of Mechanical Engineering Science, 1961
- LXXXI. Stresses and strains in tube-drawingJournal of Computers in Education, 1949