Dendritic material as a dry-release sacrificial layer
- 1 June 2000
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 9 (2), 198-205
- https://doi.org/10.1109/84.846700
Abstract
A dry-release process using highly structured dendritic material, specifically, hyperbranched polymers (HBP's), has been developed. A particular HBP under study, known as HB560, has been characterized and successfully integrated with microelectromechanical systems processing. An array of electroplated nickel cantilever beams 100 /spl mu/m/spl times/100 /spl mu/m /spl sim/1000 /spl mu/m in length has been successfully fabricated and dry released. The required release time is 10 min at 600/spl deg/C in O/sub 2/. Single open-ended microchannels were fabricated to determine the etch time and tunneling length achieved using HB560 as a sacrificial material. The time improvement for the sacrificial release is on the order of 40/spl times/ compared to standard HF wet-etch processes. Etch lengths of 1 cm have been successfully demonstrated with a sacrificial layer aspect ratio of 1600. A photosensitive version of the dendritic material has also been synthesized and characterized to reduce the process steps.Keywords
This publication has 12 references indexed in Scilit:
- A novel method to avoid sticking of surface micromachined structuresPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Polysilicon Surface Modification Technique To Reduce Sticking Of MicrostructuresPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Advances in processing techniques for silicon micromechanical devices with smooth surfacesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- The effect of release-etch processing on surface microstructure stictionPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Self-assembled fluorocarbon films for enhanced stiction reductionPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- A MEMS-based projection displayProceedings of the IEEE, 1998
- Comparative evaluation of drying techniques for surface micromachiningSensors and Actuators A: Physical, 1998
- Dry release for surface micromachining with HF vapor-phase etchingJournal of Microelectromechanical Systems, 1997
- Solid-Supported Hyperbranched Polymerization: Evidence for Self-Limited GrowthJournal of the American Chemical Society, 1997
- Dendrimer MoleculesScientific American, 1995